The awning s settings and electricity supply are also common sources of trouble.
Sunsetter awning led lights not working.
As you continue to hold the down button the led lights will dim down to fully off.
Check power at the quick connect outlet or power source.
Control box the first time the led light system is plugged in.
You should always troubleshoot your awning before calling the manufacturer to see if you can solve the problem yourself.
Verify that the red light on the remote transmitter comes on when you press and hold the button.
Be sure to order dimming led lights for your sunsetter awning.
If the remote control stops working with the awning it needs to be reset.
Unplug the power cord from the wall.
There s a dedicated circuit breaker for the power converter.
Sunsetter recommends channel 1 be used to operate your awning and channel 2 be used to operate your led light system unless you did not purchase a motorized awning then use channel 1 to operate your led light system.
T z z á z u o u µ o o ç v z o µ o z á v v p o v p x.
If the red light does not come on at all or blinks for less than 5 seconds you will need to replace the battery see care and maintenance section on page 15.
The reset process appears convoluted but when followed closely it will reconnect the remote control with the motor control unit.
How to use the multi channel remote transmitter see figures 13 14.
Test to see if this restored operation if not continue to the next step.
If not replace the cr2430 battery.
If it does continue to the next step.
Step 1 push the middle button on the remote control and unplug the awning s power cord from the electrical outlet.
Dimming the led strip off when the led light strip is fully on press and hold for more than second the down button on the remote transmitter.
If still not working you ll need to locate the power converter and make sure it s plugged into it s outlet.
Plug in the power cord and close the awning the rest of the way.
Press the neutral middle button on the transmitter.
The set is cream colored to match your awning s hardware perfectly.
If there is power present continue to the next step.
Sunsetter recommends channel 1 be used to operate your awning and channel 2 be used to operate your led light system unless you did not purchase a motorized awning then use channel 1 to operate your led light system.
You get a set of lights for each arm plus a waterproof transformer box that converts 110 volt to 12 volt to save energy.
How to use the multi channel remote transmitter see figures 13 14.
When a desired dimming level has been achieved release the down button.
Control box the first time the led light system is plugged in.
Unplug the motor and plug it back in.
Press and hold my for 8 seconds the light should blink the entire time.
The awning s motor or remote control is usually to blame when the unit stops working as you expect.
